Operation Manual
Table Of Contents
- About this Manual
- First things first
- 1 Getting started
- 2 Entering data in your Acer n35
- 3 Managing applications and information
- 4 Managing Microsoft® Pocket Outlook applications
- 5 Managing Microsoft® Pocket PC 2003 SE companion programs
- 6 Backup and restore data
- 7 Using expansion features
- 8 Exchanging and updating data using ActiveSync®.
- 9 Getting connected
- 10 Using Microsoft® Pocket Internet Explorer
- 11 Customising your handheld
- Appendix A: Regulation & safety notices
- FCC notice
- Notice: Shielded cables
- Notice: Peripheral devices
- Caution
- Operation conditions
- Notice: Canadian users
- Remarque à l’intention des utilisateurs canadiens
- Declaration of Conformity for EU countries
- Important safety instructions
- LCD pixel statement
- Radio device regulatory notice
- General
- European Union (EU)
- List of applicable countries
- The FCC RF safety requirement
- Canada - Low-power license-exempt radio communication devices (RSS-210)
- Exposure of humans to RF fields (RSS-102)
- Environmental Policy Declaration
1 Getting started
Preparing to use your Acer n35
9
To use car holder
1. Attach gooseneck firmly to holder
2. Suction mount the car holder to windshield or any flat, smooth surface.
Alternatively, use self-adhesive power disc to mount on other surface.
3. Flip up the GPS antenna of the Acer n35 handheld then adjust it in the
holder. Squeeze sides to close and hold tight (press button to release).
4. If you want your Acer n35 handheld to be charged while driving, please apply
the car charger (see below for instruction).
NOTE: Note: Never leave your handheld or the mount in extreme heat.
To use car charger to charge your Acer n35.
1. Connect car charger to the adaptor connector of the handheld.
2. Plug adaptor connector into 26-pin I/O connector of the Acer n35 handheld
and plug car charger into cigarette lighter.
Preparing to use your Acer n35
Perform the following easy installation tasks to begin using your handheld:
• Install the Microsoft
®
ActiveSync
®
software in your computer
• Connect the cable
• Charge your handheld
• Set up your handheld
• Perform the first ActiveSync operation