Instruction Manual

1 Getting started

To use car holder

1. Attach gooseneck firmly to holder

2. Suction mount the car holder to windshield or any flat, smooth surface.

Alternatively, use self-adhesive power disc to mount on other surface.

3. Flip up the GPS antenna of the Acer n35 handheld then adjust it in the

holder. Squeeze sides to close and hold tight (press button to release).

4. If you want your Acer n35 handheld to be charged while driving, please apply

the car charger (see below for instructions).

NOTE: Never leave your handheld or the mount in extreme heat.

To use car charger to charge your Acer n35.

1. Connect car charger to the adaptor connector of the handheld.

2. Plug adaptor connector into 26-pin I/O connector of the Acer n35 handheld

and plug car charger into cigarette lighter.

Preparing to use your Acer n35

Perform the following easy installation tasks to begin using your handheld:

• Install the Microsoft

ActiveSync

software in your computer

• Connect the cable

• Charge your handheld

• Set up your handheld

• Perform the first ActiveSync operation