User Manual

English
6
First things rst
Usage Notes
Do:
y Turn o󰀨 the product before cleaning.
y Use a soft cloth moistened with mild detergent to clean the displayhousing.
y Disconnect the power plug from AC outlet if the product is not being used for a long period of time.
Don’t:
y Block the slots and openings on the unit provided for ventilation.
y Use abrasive cleaners, waxes or solvents to clean the unit.
y Use under the following conditions:
y In extremely hot, cold or humid environments.
y In areas susceptible to excessive dust and dirt.
y Near any appliance that generates a strong magnetic eld.
y Place In direct sunlight.
Precautions
Follow all warnings, precautions and maintenance as recommended in this user’s guide to maximize the life of your
unit.
Warning!
y Do not look into the projector’s lens when the light is on. The bright may hurt your eyes.
y To reduce the risk of re or electric shock, do not expose this product to rain or moisture.
y Please do not open or disassemble the product as this may cause electric shock.
y When switching the projector o󰀨, please ensure the projector completes its cooling cycle before disconnecting
power.
y Turn on the projector rst and then the signal sources.
y Do not use lens cap when projector is in operation.
Cleaning the lens
y Before cleaning the lens, be sure to turn o󰀨 the projector and unplug the power cord to allow it to completely
cool down.
y Use a compressed air tank to remove the dust.
y Use a special cloth for cleaning lens and gently wipe the lens. Do not touch the lens with your ngers.
y Do not use alkaline/acid detergents or volatile solvents such as alcohol for cleaning lens. If the lens is damaged
due to the cleaning process, it is not covered by the warranty.
Warning! Do not use a spray containing ammable gases to remove dust or dirt from the lens. This may
cause a re due to excessive heat inside the projector.
Warning! Do not clean the lens if the projector is warming up as this may cause the lens’ surface lm to
peel o󰀨.
Warning! Do not wipe or tap the lens with a hard object.