Technical information

Chapter 3 71
22. Unscrew the two screws holding the main board to the main frame.
23. Remove main board from the main frame.
24. Remove the two screws holding the MDC card.
25. Disconnect the MDC card connector and modem wire. Then remove the MDC card.
26. Insert the pins of the tweezers to the holes as red circles highlight. Press the tweezers inwards as the
yellow arrows show. Then pull out the connector.
27. Then remove the MDC cable.
NOTE: Please see the image below for the tweezers used. You can also use any tweezers as long as it will not
damage MDC cable connector.
Specification: AA120mm
28. Remove the three holding the support bracket.
29. Remove the support bracket.