Specifications

PC/II+p Board Technical Reference Manual 92

11.3.9 Option S – Serial I/O

1 1 SERIAL PORT (COM1), standard RS-232, with drivers/receivers, pulled to MASS I/O

Connector; included in base board

2 2 SERIAL PORTS (COM1 & COM2), standard RS-232, with drivers/receivers, pulled to

MASS I/O Connector

NOTES. One port (COM1) is included in the base board, and an appropriate MASS I/O connector is required

to interface the serial channel[s] to external serial devices; see options "Y" and "Z".

11.3.10 Option V – Video

0 NONE

1 VIDEO

Video Option with 4MB Video Memory; all video (both CRT and 24-bit panel interfaces) are

pulled to the Mass I/O Connector

11.3.11 Option X – PC104

0 NONE

1 8-BIT Non-stackthrough Headers

2 8-BIT Non-stackthrough Sockets

3 8-BIT Stackthrough Headers

4 8-BIT Stackthrough Sockets

5 16-BIT Non-stackthrough Headers

6 16-BIT Non-stackthrough Sockets

7 16-BIT Stackthrough Headers

8 16-BIT Stackthrough Sockets

C CUSTOM

11.3.12 Option Y – MASS I/O 5X11

0 NONE

1 Mass I/O 5X11 Straight Receptacle – AMP Z-PACK IEC 2MM HM

2 Mass I/O 5X11 Right Angle Plug – AMP Z-PACK IEC 2MM HM

3 Mass I/O 5X11 Straight Plug – AMP Z-PACK IEC 2MM HM

4 Mass I/O 5X11 Right Angle Receptacle – AMP Z-PACK IEC 2MM HM

C CUSTOM

NOTES. Mass I/O J903 and J904 Connectors are normally required if any peripheral function except for

Ethernet is required; If in doubt, please refer to section 9

of this document, for a complete list of peripheral

groups that require this option.