User Guide

Before radio devices can be put in circulation, their agreement
with European laws or limits must be confirmed; only then may
the CE symbol be applied.
The unit of measurement for the European Council's
recommended limit for mobile telephones is the "Specific
Absorption Rate" (SAR). This SAR limit is 2.0 W/kg, averaged
over 10 g of body tissue. It meets the requirements of the
International Commission on Non-Ionizing Radiation
Protection (ICNIRP) and was included in the European
Standard EN 50360 for mobile radio devices. The SAR
regulation for mobile telephones is in line with European
Standard EN 62209-1. The maximum SAR value is calculated
at the highest output level in all frequency bands of the mobile
telephone.
For body worn operation, this phone has been tested and
meets the ICNIRP exposure guidelines, and was included in
the European Standard EN 62311 and EN 62209-2 for use
with accessories that contain no metal and that position the
handset a minimum of 1.5 cm from the body. Use of other
accessories may not ensure compliance with ICNIRP
exposure guidelines. If you do not use a body-worn accessory
and are not holding the phone at the ear, position the handset
a minimum of 1.5 cm from your body when the phone is
switched on.
During use, the actual SAR level is usually much lower than
the maximum value, because the mobile telephone works in
different output levels. It only transmits with as much output as
is required to reach the network. In general the following
applies: The closer you are to a base station, the lower the
transmission output of your mobile telephone. The tested SAR
of this device is as follows:
Head (W/kg) Body (W/kg)
0.78 1.33