User`s guide

Jumper and Connector Locations 5-7
1. Locate the RTCRST# jumper.
2. Use an electric conductivity tool to short the two points of the RTCRST# jumper.
3. Plug in AC, keeping the RTCRST# jumper shorted.
4. Press Power Button until BIOS POST is finished, then remove the conductivity tool from
the RTCRST# jumper.
5. Restart the system. Press F2 to enter BIOS Setup menu.
6. If there is no Password request, BIOS Password is cleared.
7. If a password is requested, repeat Steps 1 through 6.
Clear CMOS Jumper 0
Figure 5-4. CMOS Jumper