Technical data

Acer | HDS AMS200 User and Reference Guide 279
Appendix B System Parameter Settings List
The following table lists the parameter settings using the Storage Navigator-Modular.
System Parameter
1 System Startup Attribute Depends on System Configuration
2 Drive Detach mode enable Disable (Standard setting)
3 Turbo LU Warning Disable (Standard setting)
4 Operation if the Processor failures Occurs Reset a Fault (Standard setting)
5 ROM Microprogram Version No change is needed
6 RAM Microprogram Version No change is needed
7 Write & Verify Executing Mode On (Standard setting)
8 DHCP (Note 2) OFF (Standard setting)
9 Maintenance Port IP Address To be set according to the network setting
10 IP Address To be set according to the network setting
11 Subnet Mask To be set according to the network setting
12 Default Gateway To be set according to the network setting
Host Group
1 LU Mapping Mode Depends on the System Configuration (Note 1)
Target (Note 3)
1 LU Mapping Mode Depends on the System Configuration
Note 1: When the AMS200 is connected, the logical unit which is not wanted to be accessed
by the port must be masked by means of the LU mapping mode.
Note 2: When the DHCP mode is validated, the IP Address is acquired from the DHCP server.
If the DHCP server is not started up or the DHCP function has been wrongly set, the
acquisition of the IP Address will fail and the IP Address of the subsystem will remain
“0.0.0.0”. (This is a state in which Storage Navigator-Modular or the Web cannot be used via
a LAN.)
Note 3: Effective only when the iSCSI interface is added.