User Guide

Chapter 3 44
Removing the Lower Case
1. Remove the six screws fastening the lower case as shown.
2. Detach the lower case from the ezDock carefully.
Removing the Harness Cable Set
1. Remove two hex screws on the I/O bracket as shown.
2. Disconnect the power cable, then remove six screws fastening the cables and boards as shown.
3. Remove the two screws fastening the hinge cover then remove the cover from the ezDock.
See below images for more details about step 2.
4. Then remove the four screws fastening Ethernet board and PCI-E board. Then disconnect the Ethernet
board, the cable and the PCI-E board.
5. Detach the Harness cable set from the ezDock.