Operation Manual

13
Other Settings
Note: The following content is for general reference only. Actual
product specifications may vary.
Signal Source
M
ode
Aspect Ratio
DCR
0n Off
PC GAME MOVIE
16:9 AUTO 4:3
VGA
DVI
1920 1080
Over Drive
0n Off
Purpose:
You can set Mode,Signal Source,Aspect Ratio,DCR,Over Drive,Blue Light Filter.
Steps:
1.Press MENU key to enter the main menu interface.
2.Press triple◄ key and press MENU key to enter the Mode interface, press ◄ or ► to switch the mode
between PC/GAME/MOVIE.
3.Press ◄ or ► to change the Signal Source between VGA and DVI.
4.Press ◄ or ► to switch the Aspect Ratio between 16:9/AUTO/4:3.
5.Press ◄ or ► to switch the DCR On/Off.
6.Press ◄ or ► to switch the Over Drive On/Off.
7.Press ◄ or ► to adjust “Blue Light Filter”from 0 to 100.
Blue Light Filter
0 -
Attention:The “Blue Light Filter”function is in the next page of OSD.
8.Press Menu key to return to the main menu after accomplishing the adjustment.