User's Manual

Troubleshooting Tips

The LCD panel remains blank when I press the POWER button and can't take

pictures.

Check that the battery is correctly inserted. If it is old, replace it.

The camera can not take a picture.

When the FLASH indicator is on, it takes up about 15 seconds to charge the flash light

for the next shot. During this time the camera is busy and cannot take pictures. Wait

until the indicator becomes OFF.

Cannot download all my images from my camera to PC.

The RAM memory installed in your computer may not have sufficient storage space.

Close all software programs and proceed to download your images. If the problem per-

sists, download images in batches and store each batch in your hard drive before pro-

ceeding to the next batch. Make sure all the images you want are stored prior to

clearing the camera memory.

I have connected the camera to the computer, but the Digital Camera 300

driver says “Device not ready!”.

Make sure that the batteries are installed correctly and there is enough power in

them.

Check if the camera power is turned on. If not, turn it on and then connect the camera

to the computer again.