User Guide
Table Of Contents
- Information for your safety and comfort
- Safety instructions
- Special notes on LCD monitors
- Cleaning your monitor
- Accessibility
- Safe listening
- Warnings
- Using electrical power
- Product servicing
- Potentially explosive environments
- Additional safety information
- IT Equipment Recycling Information
- Disposal instructions
- LCD pixel statement
- Tips and information for comfortable use
- Finding your comfort zone
- Taking care of your vision
- Developing good work habits
- Federal Communications Commission Supplier's Declaration of Conformity
- TCO Certified
- Unpacking
- Connecting the Power cord
- Power saving
- Installation
- Daisy-chain function
- User Controls
- Troubleshooting
HDMI 1 -- X O
HDMI 2 X -- O
DP O O --
X: Does not support PIP/PBP function in this input combination
9. Hotkey Assigment: Hot Key 1 and Hot Key 2 can’t repeat the same function. Hot Key
1 default is (Modes), Hot Key 2 default is (Brightness). Because some functions limit
the Hot Key to be gray out and unavailable. Hot Key can dene of: (Modes, Brightness,
Volume, Gamma, Contrast, Low Blue Light, Over Drive, USB Port Select, PIP/PBP).
10. DDC/CI: Allows the monitor settings to be set through the software on the PC.
-----------------------------------------------------------------------------------------------------------
Note:
DDC/CI, short for Display Data Channel/Command Interface, which allows
monitor controls to be sent via software.
11. ProxiSense: ProxiSense works on principle of transmission and reception of harmless
“infrared” signals in order to detect user-presence.
-----------------------------------------------------------------------------------------------------------
Note:
• The ProxiSense is set to (Range 1 to Range 3), tolerance is (+/-) 20 cm and
ACM is o.
• Three status (No signal, no cable connection and out of range) does not
support ProxiSense.
• The ProxiSense controls the PWM to 50% (current OSD Brightness
parameter) or into the power saving state, and then press any key to restore
the PWM to the normal value.
• Power The detection range of the Sensor is in the middle, the upper and
lower angles are ignored.
12. Rest Reminder: ProxiSense is set Range1~Range3 then Rest Reminder can be control
(O ~ 100Mins), Rest Reminder default is O.
-----------------------------------------------------------------------------------------------------------
Note:
• ProxiSense must be set to Range 1 and Range 3 before the Rest Reminder
can be opened for selection (O /20 Mins /40 Mins /60 Mins /80 Mins /100
Mins ), The default setting is O to not remind.
• Reminder message will display in the middle of the screen, press any
key except the power button to hide the message, The Duration time of
Reminder message depend on OSD Timeout function.
• When set to (20 Mins ~ 100 Mins), because the ProxiSense continues to
detect people, it will continue to time. When the set time is reached, the
Reminder Message will be displayed, will be displayed, as shown in the
gure above.
13. HDMI Black level setting.
14. Quick start mode: Select O or On. Turn on to speed up boot speed.
15. USB Port Select:Select the USB Port from (Auto/B-Type/C-Type), default is Auto.
-----------------------------------------------------------------------------------------------------------
Note:
• Auto switch according to the currently lit signal source. If the current display
is HMDI/DP, it will auto switch to B-Type, and if the current display is DP
ALT, it will auto switch to C-Type.