Safety Guide

Warn i ngs and regulatory formation - 23


USA - FederalCommunications Commission ( FCC )


Note
The radiated output power of the adapter is far below the FCC radio
frequency exposure limits. Neverthele ， th e adapter shouldbe usedin such
a manner that the potentialfor human contact during normaloperation is
minimized. To avoid the possibility of ex ng the FCC radio frequency
exposure
limits ， you should keep a distance of at least 20 cm between you
(or any other person in the vicinity)
，or the minimum separat i ∞ distance as
specified by the FCC grant conditions ， and the antenna that is built into the
compute
r. Oetails of the authorized configurations can be found at
www.fcc.gov/oetle a/ byentering th e FCC 10 number on the device

This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
• 15.21
You are
cautioned that changes or modifications not expressly
approved
by the paresponsible for compliance could void the
user's authority to operate the equipmen t.
Intet1erence
statement
This wireless adapter has been tested and found to comply with the
limits for a Class B digital device ， pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This wireless
adapter generates ， uses ， and can radiate radio frequency energy. If
the
wireless adapter is not installed and used in accordance with the
instructions ， the wireless adapter may cause harmful interference to
radio
communications. There is no guarantee ， however ， that such
interference will not occur in a pa icular installation. If this wireless
adapter does cause harmful interference to radio or television
reception (which can be determined by turning the equipment off and
on) ， th e user is encouraged to try to correct the interference by taking
one or more of the
following measures:
•
Reorient or relocate the receiving antenna of the equipment
experiencing the interference