Technical information

26 Chapter 2
Power
The Power screen allows the user to configure CPU and power management options.
The table below describes the parameters in this screen. Settings in boldface are the default and suggested
parameter settings.
Parameter Description Submenu Items
Advanced CPU
Control
Enter the Advanced CPU Control menu. • IST Configuration
• Thermal Mode
• CMP Support
• Use NX capability
• C-State support
• Enhanced C-States Enable
• Pop Up Support
• Pop Down Support
•Hard C4E
• Bi-directional PROCHOT#
• ACPI 3.0 T-States
• DTS Enable
• Thermal Trip Points Setting
(Throttle On Temp.)
Platform Power
Management
Enter the Platform Power Management
menu.
• PCI Clock Run
• _CST - C4 Latency Value
ACPI S3 Enable or Disable ACPI S1/S3 Sleep State. N/A
Wake on PME Disable or Enable wake up when the
system power is off and a PCI Power
Management Enable wake up event occurs.
N/A
Wake on Modem
Ring
Disable or Enable wake up when the
system power is off and a modem attached
to the serial port is ringing.
N/A
Item Specific Help
These items control
various CPU parameters.
F1
ESC
Help
Exit
Select Item
Select Menu
Change Values
Select SubMenu
Enter
F9
F10
Setup Default
Save and Exit
[Enabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[Enabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
X Advanced CPU Control
X Platform Power Management
ACPI S3:
Wake on PME
Wake on Modem Ring
Auto wake on S5
Quickly S4 Resume
X Advanced CPU Control
X Platform Power Management
ACPI S3:
Wake on PME
Wake on Modem Ring
Auto wake on S5
Quickly S4 Resume
F5/F6
InsydeH20 Setup Utility Rev. 3.5
Boot
Exit
SecurityInformation
Advanced PowerMain