Technical information

Step 1:

Step 2:

Step 3:

Step 4:

Step 5:

Step 6:

Step 7:

Step 8:

Picture8

Step 9:

Step 10:

1-4: Create SATA RAID 0+1

Shut down the EUT, unplug the power cable,connect four SATA HDDS to EUT , check the

EUT all devices are connect/plug ok

Press "PWR-BTTN" to power on the EUT,Load BIOS default setting .

At "Integrated_Peripherals" page "OnChip SATA Type" item set is as "RAID" mode,save

and exit.

During BIOS post, press <Ctrl-I> to enter into Intel RAID setup utility.

Select "1" to enter create RAID mode ,if there is no enough avalable space (there was exist a

Raid , delete it ).

Repeat RAID1 creation step and exit,then install OS.

Create RAID 0+1 Mode,firstly create RAID 0 Mode,enter the RAID name,such as

"MyRaid0+1",default is"Volume0".

Select "RAID0(Stripe)" at "RAID Level".

Select two HDDs in "Disk" by space key.

Press "Enter" to finish HDD selection and it will back to RAID creation interface.