Technical information

50 Chapter 2
ACPI Suspend Type
You can use this item to define how your system suspends. In the default, S3 (STR), the suspend
mode is a suspend to RAM, i.e., the system shuts down with the exception of a refresh current to
the system memory.
Soft-Off by PWR-BTTN
Under ACPI (Advanced Configuration and Power Management Interface) you can create a
software power down. In a software power down, the system can be resumed by Wake Up Alarms.
This item lets you install a software power down that is controlled by the power button on your
system. If the item is set for Instant-Off, then the power button causes a software power down. If
the item is set for Delay four Sec., then you have to hold the power button down for four seconds to
cause a software power down.
Energy Lake Function
This item enables or disables the Energy Lake Function.
Resume by PCI PME
This item specifies whether the system will be awakened from power-saving modes when activity
or input signal of the specified hardware peripheral or component is detected.
Wake Up On LAN
When it is set for Enabled, you can remotely wake up a PC in Soft-Off condition via a LAN card that
supports the wake up function.
Resume by Alarm
When it is set for Enabled, additional fields become available and you can set the date, hour,
minute and second to turn on your system. When it is set for zero in the column of date, the alarm
will power on your system every day at the specified time.
Power On After Power Fail
This item enables your computer to automatically restart or return to its last operating status after
power returns from power failure.