User guide

59
Installing an expansion card
Your server has a preinstalled riser card designed specifically for use in
the 2U rackmount chassis. Depending on the type of riser card
installed, you can install the following expansion cards:
• Left riser card (pre-installed)
• One Acer Flex I/O (PCI-E 2.0 x8) slot
• Two full height PCI-E 2.0 x8 slots (with x4 link)
• One full height PCI-E 2.0 x16 slot (with x8 link)
• Right riser card (optional)
• Three low profile PCI-E 2.0 x8 slots (with x4 link)
Installing a SAS card
1 Observe the pre-installation instructions on page 26.
2 Unclip the restraining latch and open in the direction shown
below (1).
3 Remove the slot shield (2).