Manual

53
(2) Connect the SAS/SATA2 cable to the SAS/CON connector
of the backplane board.
6 Observe the post-installation instructions described on page 42.
For instructions on how to install a hard drive in an easy-swap HDD
cage, go to page 57.
For instructions on how to install a hard drive in a hot-plug HDD
cage, go to page 55.
Removing a HDD cage
1 Perform the pre-installation instructions described on page 41.
2 Prepare the HDD cage for removal.
• For a hot-plug HDD cage, disconnect the data and power
cables from the backplane board, then remove all HDDs from
the cage.
• For an easy-swap HDD cage, disconnect the data and power
cables from their HDD connectors, then remove all HDDs from
the cage.
3 Remove the HDD cage.
(1) Move the release slider all the way up to unlock the hot-plug
HDD cage.