Owner manual

3 Upgrading the system
74
To install an expansion card
Note: The illustrations used in this section show the Altos G510
server chassis.
1 Observe the ESD precautions and pre-installation procedures
described on page 36.
2 Locate an empty expansion slot on the mainboard.
3 Loosen the bracket screw on the rear panel.(1).
4 Pull out the card bracket (2).
5 Remove the expansion card from its protective packaging.
6 Align the card in the empty slot on the mainboard. Make sure that
the card is properly seated.
7 Insert the bracket with the card into the selected slot (1).
BB!H621!.!FO/cppl!!Qbhf!85!!Uivstebz-!Kvof!23-!3114!!2;34!QN