Desktop PC User's Guide
Table Of Contents
- Notices
- Important safety instructions
- 1 System tour
- 2 System setup
- 3 Upgrading the system
- 4 BIOS setup
- Appendix A: ASM Quick Installation Guide
- Appendix B: Altos G510 Rack Installation Guide
- Index
47
To install the Hot Plug HDD cage
1 Detach the chassis panels and remove the air baffle.
2 Connect the following cables to the SCSI backplane board:
a SCSI cable
b SCSI HDD 6 pin management cable
c SCSI HDD power cable
3 Insert the Hot Plug HDD cage into the housing (1), then tighten
the four thumbscrews to secure it to the chassis (2).
4 Attach the other end of these cables to the corresponding
connectors on the mainboard.
Refer to “Mainboard layout” on page 14 for the location of the
connectors.
BB!H621!.!FO/cppl!!Qbhf!58!!Xfeoftebz-!Kbovbsz!9-!3114!!21;63!BN