User manual

59
Drive Configuration
Mode Sets the operation mode for the parallel port. When
set to output only, allows normal speed one-way
operation. When Bi-directional, allows normal speed
operation in a two way mode. EPP (Enhanced Parallel
Port) allows bi-directional parallel port operation at
maximum speed. ECP (Extended Capabilities Port)
allows the parallel port to operate in bi-directional
mode and at a speed higher than the maximum data
transfer rate.
Output only
Bi-directional
EPP
ECP
Onboard Gb
LAN
Sets onboard Gb LAN Enabled
Disabled
Onboard 10/
100 LAN
Sets onboard 10/100 LAN Enabled
Disabled
ASF Support Sets ASF support Enabled
Disabled
BIOS SETUP UTILITY
Advanced
Drive Configuration
ATA/IDE Configuration [Enhanced]
Intel(R) RAID Technology [Disabled]
SATA AHCI Mode [Disabled]
PCI IDE Bus Master [Enabled]
Hard Disk Pre-Delay [Disabled]
? [SATA Port-0 : :WDC WD1200JD-22GBB0]
? [SATA Port-2 : Not Detected]
? [SATA Port-1 : Not Detected]
? [SATA Port-3 : Not Detected]
? [PATA Master : CD-ROM 52X/AKH]
? [PATA Slave : Not Detected]
Disabled: All IDE
resources disabled
LEGACY: Up to 2 IDE
channels enabled for OS
requiring legacy IDE
operation
ENHANCED: All SATA and
PATA resources enabled
←→
Select Screen
↑↓
Select Item
Enter Select ? Sub-Menu
Tab Select Field
F1 General Help
F9 Setup Defaults
F10 Save and Exit
ESC Exit