User manual

6 Troubleshooting
96
A: Drive Error
B: Drive Error
No response from the floppy disk drive.
CMOS Battery Low The battery may be losing power. Replace the
battery soon.
CMOS Display Type Wrong The display type is different than what has
been stored in CMOS. Check Setup to make
sure type is correct.
CMOS Checksum Bad The CMOS checksum is incorrect. CMOS
memory may have been corrupted. Run
Setup to reset values.
CMOS Settings Wrong CMOS values are not the same as the last
boot. These values have either been
corrupted or the battery has failed.
CMOS Date/Time Not Set The time and/or date values stored in CMOS
are invalid. Run Setup to set correct values.
DMA Error Error during read/write test of DMA
controller.
FDC Failure Error occurred trying to access floppy disk
drive controller.
HDC Failure Error occurred trying to access hard disk
controller.
Checking NVRAM..... NVRAM is being checked to see if it is valid.
Update OK! NVRAM was invalid and has been updated.
Updated Failed NVRAM was invalid but was unable to be
updated.
Keyboard Is Locked The system keyboard lock is engaged. The
system must be unlocked to continue to boot.
Keyboard Error Error in the keyboard connection. Make sure
keyboard is connected properly.
KB/Interface Error Keyboard interface test failed.
Error Message Explanation