Technical information

MACHINE ASSEMBLY

This chapter contains step-by-step procedures on how to assemble the monitor for maintenance

and troubleshooting.

NOTE:

1. The screws for the different components vary in size. During the disassembly process, collect the screws with the

corresponding components to avoid mismatch when putting back the components.

2. The monitor surface is susceptible to scratching! Therefore, lay the monitor on a soft surface when mounting or

removing the base.

3. Wear gloves

Chassis*1

Front bezel*1

Button*1

Indicator*1

Hinge cover*1

INL Panel*1

SCREW (PW3x4,M,ZN)*4

FFC(30pin)*1

TAPE,ACE#LP1701(40x20mm)*1

INSULATOR PC#LE1710

PCBA I/F BOARD *1

CABLE 30P FFC

HRN ASS’Y 8P

SCREW (PW 3*6,M,ZN) *3

PCBA Power Board *1

INSULATOR PC,MYLAR

SCREW (PW 3*6,M,ZN) *3

PCBA Control Board *1

SCREW (PW 3*4,M,ZN)

Insert B/L jack*4

Back cover*1

Arm Stand*1

(M4x10,ZN)*4

Stand plate*1

Rubber*4

Bracket Finger

EMI shield Tape*2

Chapter 3