Technical information

Chapter 2 38
Integrated Peripherals
All onboard peripherals can be set up through this menu.
Parameter Description Options
On-Chip Primary PCI IDE Enabled : Enable onboard 1st channel IDE port.
Disabled : Disable onboard 1st channel IDE port
On-Chip SATA Mode Disabled : Disable this function
Auto : BIOS will auto detect
Combined : Set On-Chip SATA mode to Combined, you can use up to 4 HDDs on
the motherboard; 2 for SATA and the other for PATA IDE.
Enhanced : Set On-Chip SATA mode to Enhanced, the motherboard allows up to 6
HDDs to use
Non-Combined : Set On-Chip SATA mode to Non-Combined, SATA will be simulated
to PATA mode.
PATA IDE Set to Ch.1 Master/Slave : Set PATA IDE to Ch. 1 Master/Slave.
Ch.0 Master/Slave : Set PATA IDE to Ch. 0 Master/Slave.
SATA Port 0/2 Set to This value will auto make by the setting "On-Chip SATA Mode" and "PATA IDE Set to".
If PATA IDE were set to Ch. 1 Master/Slave, this function will auto set to Ch. 0 Master/
Slave.
SATA Port 1/3 Set to This value will auto make by the setting "On-Chip SATA Mode" and "PATA IDE Set to".
If PATA IDE were set to Ch. 0 Master/Slave,this function will auto set to Ch. 1 Master/
Slave.
USB 2.0 Controller Enable this item if the system supports USB 2.0 Enabled : Enable USB 2.0
Controller
Disabled : Disable USB 2.0
Controller
USB Controller This item is used to enable or disable the on-chip
USB
Enabled : Enable USB Controller
Disabled : Disable USB Controller
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
Integrated Peripherals
On-Chip Primary PCI IDE [Enabled]
On-Chip SATA Mode [Enhanced]
x PATA IDE Set to Ch.0 Master/Slave
SATA Port 0/2 Set to Ch.2 Master/Slave
SATA Port 1/3 Set to Ch.3 Master/Slave
USB Controller [Enabled]
USB 2.0 Controller [Enabled]
USB Keyboard Support [Enabled]
USB Mouse Support [Enabled]
AC97 Audio [Auto]
Onboard H/W LAN [Enabled]
Onboard LAN Boot ROM [Disabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [SPP]
x ECP Mode Use DMA 3
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F7: Default Settings
Item Help
Menu Level`