Technical information

32 Chapter 2
Super IO Device
Press [Enter] to enter the sub-menu and the following screen appears:
Soupier Device
Parameter Description Option
POWER ON Function This option is used to set the power on
method for your PC.
Any Key
Button Only
Onboard FDC Controller Enables or disables the onboard floppy disk
drive controller.
Enabled
Disabled
Onboard Serial Port 1
Onboard Serial Port 2
This option is used to assign the I/O
address and interrupt request (IRQ) for
onboard serial port 1 and port 2
(COM1,COM2).
Disabled
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Auto
Onboard Parallel Port This option is used to assign the I/O
address and interrupt request (IRQ) for the
onboard parallel port.
Disabled
378/IRQ7
278/IRQ5
3BC/IRQ7
Parallel Port Mode Enables you to set the data transfer protocol
for your parallel port.
SPP (Standard Parallel Port), EPP
(Enhanced Parallel Port), ECP (Extended
Capabilities Port) and ECP+EPP.
SPP
EPP
ECP
ECP+EPP
Normal
EPP Mode Select Select a DMA Channel for the parallel port
when using the ECP mode. This field is only
configurable if Parallel Port Mode is set to
ECP.
EPP1.9
EPP1.7
ECP Mode Use DMA When the onboard parallel port is set to
ECP mode, the parallel port can use DMA 3
or DMA 1.
1
3