User guide

363
Protocol Migration This parameter controls the migration from RSTP to
STP, if the other side of the switch runs STP. The
migration takes place only if this is
Enabled .
PortFast This parameter must be configured, if the
corresponding port is an edge port.
Point-to-Point This parameter allows you to configure ports explicitly
as
Point-to-point (Force true), Non-point-to-point or
leave the decision to be made
Dynamically (from the
AL or MAC layer).
Auto Edge Status If this parameter is set to
true , the edge port status is
dynamically calculated.
Restricted Role This parameter specifies the R
ESTRICTED ROLE status of
the port.
Restricted TCN This parameter indicates the R
ESTRICTED TCN status of
the port.
Parameter Description