User guide

4 Networking Switch Modules
324
QoS Classmap Settings
Clicking the CLASSMAP tab brings up the QOS CLASSMAP SETTINGS page,
which is used to classify the stream of traffic. The parameters for this
page are shown in the following table.
Parameter Description
System Control With this parameter S
YSTEM CONTROL can Start or
Shutdown QoS.
Status This parameter allows enabling/disabling of the QoS
status.
Figure 4-207. QoS Classmap Settings
Parameter Description
Classmap ID This parameter specifies a unique ID for the Classmap.
It must be in the range from
1 to 65535 .
Filter ID This parameter specifies the unique filter ID associated
with this Classmap.