User Guide

© 2003, Adaptec, Inc. 165
402 Name MLXEV_CTLDEV_BBU_RECOND_ABORT
Description Battery reconditioning is canceled.
Cause User cancelled the battery reconditioning.
Action Restart the battery reconditioning, if required.
Address ctl: 0
Severity 4 (Information)
Source ExPro
403 Name MLXEV_CTLDEV_INSTALLATION_ABORT
Description Installation aborted.
Cause Equipment improperly set up while powered off.
Action Re-establish proper setup.
Address ctl: 0
Severity 1 (Serious)
Source InPro
404 Name MLXEV_CTLDEV_FIRMWARE_MISMATCH
Description Controller firmware mismatch.
Cause Replacement controller with downlevel firmware installed.
Action Reload controller firmware.
Address ctl: 0 chn: 13 tgt: 14
Severity 1 (Serious)
Source Unspecified
405 Name MLXEV_CTLDEV_BBU_NORESPONSE
Description Battery removed.
Cause Battery physically removed.
Action Reinstall the battery.
Address ctl: 0
Severity 2 (Error)
Source ExPro InP_old
406 Name MLXEV_CTLDEV_WARM_BOOT_ERROR
Description WARM boot failed.
Cause Memory error detected during WARM boot scan. Possible data loss.
Action Restore data from a backup.
Address ctl: 0
Severity 1 (Serious)
Source ExPro
407 Name MLXEV_CTLDEV_BBU_CALIBRATE_START
Description Battery calibration cycle started.
Cause New battery detected.
Action None
Address ctl: 0
Severity 4 (Information)
Source ExPro
408 Name MLXEV_CTLDEV_BBU_CALIBRATE_DONE
Description Battery calibration cycle finished.
Cause Battery calibration completed successfully.
Action None
Address ctl: 0
Severity 4 (Information)
Source ExPro
Table 2 RAID Controller Event Codes