User Guide

148 Spheras Storage Director Installation and User Guide
97 Name MLXEV_PHYSDEV_TRANSPORT_ERROR
Description One or more transport errors occurred during data transfer to or from a
physical device in the last hour.
Cause Fibre Channel CRC errors were detected by the controller or a physical
device during the last hour.
Physical devices were installed or removed causing momentary Fibre
Channel loop disruption.
Physical devices are not properly seated in the enclosure.
Fibre Channel cabling or associated Fibre Channel hardware was
installed or removed.
Fibre Channel cabling or associated Fibre Channel hardware is faulty.
Enclosure, controller, or physical device is faulty.
Action Unless the problem occurs frequently, action is not required.
Refer to the enclosure manufacturer’s service manual.
Address ctl: 0 chn: 13 tgt: 14 param: 20
Severity 4 (Information)
Source ExPro
Paramtype Value
98 Name MLXEV_HOST_FIBRE_DOWN
Description The host Fibre Channel is down.
Cause Host Fibre Channel cable is disconnected or has failed.
Host Fibre Channel device (server, switch, hub, host adapter) has failed.
Host Fibre Channel interface on the controller has failed.
Action Inspect host Fibre Channel cables and associated hardware.
Address ctl: 0 chn: 13
Severity 4 (Information)
Source ExPro
99 Name MLXEV_HOST_FIBRE_UP
Description The host Fibre Channel is up.
Cause The host Fibre Channel loop initialized successfully.
Action None
Address ctl: 0 chn: 13
Severity 4 (Information)
Source ExPro
100 Name MLXEV_PHYSDEV_REDUNDANT_ACCESS_RESTORED
Description Redundant access to the physical disk has been restored.
Cause The physical disk is now accessible on both disk channels.
Action If a physical disk frequently looses redundant accessibility check I/O
modules and back-end connections.
Address ctl: 0 chn: 1 tgt: 2
Severity 4 (Information)
Source ExPro
101 Name MLXEV_SYSDEV_PFA_START
Description Started to loop through each physical disk to perform predicted failure
analysis.
Cause Controller started to perform predicted failure analysis on the physical
disks.
Action None
Address ctl: 0
Severity 4 (Information)
Source ExPro
Table 2 RAID Controller Event Codes