User Guide

105
Follow this procedure to install the Battery Backup Unit (BBU):
1 Remove the ACM from the enclosure by loosening the two ACM
screws and using the handle, slide the ACM out of the enclosure.
2 Lay the ACM on a flat surface as in above.
3 Orient the BBU as shown.
Installing the BBU
4 Feed the BBU cable through the hole provided and connect it to
the BBU connector.
5 Press the BBU into position and secure it by ensuring the four tabs
“click” into place.
6 Replace the ACM in the enclosure and tighten the ACM screws to
complete the installation.
Feed cable through
hole provided and attach
to the connector
BBU
Tabs
Tabs
BBU Connector