User Guide

Appendix D Upgrading an Altos S700 JBOD Array to a RAID Array104
5 If you are upgrading to a dual RAID configuration then repeat
steps 2 through 4 to install the second RAID controller.
6 Attach the host cable(s) to the host connector on the RAID
controller and attach the other end of the cable(s) to your HBA/
hub/switch (refer to Chapter 4 for more details).
7 Install the battery backup unit as described below.
8 Re-attach the power cables and switch on the enclosure.
9 You can now configure your RAID system using the Management
Software supplied.
Installing the Battery Backup Unit
The battery backup unit (BBU) for the RAID controller is installed on
the ACM unit.
Location of Battery Backup Unit on ACM
1
2
1
2
0
I
0
I
HBA 1
HBA 2
1
2
3
4
5
6
7
ACM Assembly
BBU goes here