User Guide

Rail Kit Installation Instructions

4. Fix the front rails to the front posts of the equipment rack and

secure in place using the Phillips Flat Head screws (10-32x.50)

and the conical washer (washer to the outside of the post).

5. Adjust the rear rails to fit the depth of the equipment rack (using

rear rails #1 or #2 as appropriate) by sliding them horizontally in

or out. Fix them to the rear posts of the equipment rack using the

Phillips Flat Head screws (10-32x.50) and conical washers

(washer to the outside of the post).

6. Tighten the Phillips SEMS Head screws (10-32x.31) that fix the

front and rear rails togethe (see Step 2).

The rail kit is now fitted and the enclosure can be installed

in the equipment rack. The following section describes how

to install the enclosure.

Installing the

Enclosure

With the rail kit fitted the enclosure is installed in the

equipment rack by following this procedure:

CAUTION: When installing or removing an equipment rack,

remove all disk drives. It is recommended that you work with at

least one other person. These precautions are necessary to prevent

personal injury and damage to the enclosure.

1. Remove all disk drives from the enclosure.

2. Slide the enclosure into the equipment rack (rail kit).

3. Secure the enclosure in position using the two Phillips Truss

Head screws (10-32 x .75 LG, Black) through the bottom two fix-

ing holes on the front of the enclosure.

4. Install the disk drives in the enclosure.