User Guide

Altos RAIDWatch User Guide
44
3.5.6.1 Base Settings
To configure the “Base Settings” select the Base Settings sub-tab from Figure 3–16 and the
configuration options shown in Figure 3–16 will appear.
• Enable: To enable the broadcast settings, select the “Enable” box in the middle of the
Broadcast Settings
window.
3.5.6.2 Broadcasting List
To configure the “Broadcasting List” select the Broadcasting List sub-tab from.Figure 3–16. The
configuration options shown in Figure 3–17 will appear.
• Host IP/Name: The IP address a broadcast message will be sent to.
• Severity: The parameter used to determine what levels of events to be sent via Broadcast (1,
all levels; 2, Warning and Alert; 3, only Alert).
• Host Name: Shows a list of all the IP addresses that the NPC will use to send a message to. Both
the IP addresses and the severity of the messages that will be sent to the address shown are
listed.
Figure 3–16 Enable Broadcast settings
Figure 3–17 Broadcasting List Settings