User Guide

Configuration Options

• Enable: To enable the SNMPTrap settings, click on the “Enable” box in the middle of the

SNMP

Settings

window.

• Community: This is just a string authentication and can be seen as a plain text password.

3.5.5.2 SNMP Trap List

To configure the “SNMP Trap List” select the

SNMP Trap List

sub-tab from Figure 3–14. The

configuration options shown in Figure 3–15 will appear.

• Host IP: The port number of the agents listening for traps. Click Add to avail agents to the

Trap

Receiver List

• Severity is the parameter used to determine what levels of events to be sent via SNMP (1, all

levels; 2, Warning and Alert; 3, only Alert).

• Host Name: A list of listening SNMP agents.

Important Agent and NPC configuration parameters can be reconfigured later using the installation program.

Run the installation program and select Configure Only from the Start menu to reconfigure Agent

and NPC settings.

3.5.6 Broadcast Settings

To open the “Broadcast Settings” window, first open the

NPC Settings

window shown in Figure 3–

6, and then select the

Broadcast Settings

sub-tab. The

Broadcast Settings

configuration window

shown in Figure 3–16 will appear. There are two sub-tabs in the

Broadcast Settings

configuration

window, “Base Settings” and “Broadcasting List”.

Figure 3–15 SNMP Trap List Settings