User Guide

Altos RAIDWatch User Guide
40
3.5.3.1 Base Settings
To open the “Base Settings” configuration window, select the Base Setting sub-tab shown in Figure
3–10.
• Enable - In the center of the
FAX settings window there is an enable option. To configure the
notification device click on the square next to “Enable.” See Figure 3–10.
3.5.3.2 Phone Number List
To open the “Phone Number List” configuration window, select the “Phone Number” list sub-tab
shown in Figure 3–10. The window shown in Figure 3–11 will appear:
• Phone Number: The phone number for an event message receiving pager. (Note that any
access dialing requirements, such as accessing an outside line, must be included in the phone
number. For example: 9,,,2241603 wherein “9” is access for an outside line and “,,,” indicates
a pause.)
• Severity is the parameter used to determine what levels of events to be sent via Pager (1, all
levels; 2, Warning and Alert; 3, only Alert).
• Available phone numbers: A list of all phone numbers that the NPC will use to send a message
to. The numbers and the severity of the messages that will be sent to the number shown are
listed.
3.5.4 Email Settings
To open the “Email” window, first open the NPC Settings window shown in Figure 3–6, and then
select the
Email sub-tab. The Email configuration window shown in Figure 3–12 will appear. There
are two sub-tabs in the
Email configuration window, “Base Settings” and “Mail Address List”
Figure 3–11 Pager Phone Number List