User Guide

21 Altos R910 Installation Configuration Guide
Windows Server 2003 Enterprise Edition (with Integrated SAS
Hardware RAID)
Below information describes how to manually install Windows Server 2003
Enterprise Edition on Altos R910 with integrated SAS hardware RAID.
Drivers Required
For Windows Server 2003 Installation, the following device drivers are required.
Device Version Directory on EasyBUILD
Onboard VGA 6.14.10.6553 \Disk\R910\onboard\VGA
Onboard Intel
E8501 Chipset
5.2.3790.1380 Built-in
Integrated SAS
hardware RAID
1.17.0.32 \Disk\r910\raid\Integrated_SAS\ws2k3
Onboard LSI 1030
SCSI controller
1.09.11.0 \Disk\R910\onboard\SCSI\LSI\ultra320.n
et
Onboard Broadcom
BCM5704 Gigabit
Ethernet
8.48.0.0 \Disk\R910\NIC\BCM\ws2003
Onboard USB 2.0 5.2.3790.1380 Built-in
SAS Hot-swap
backplane
5.0.6055.2 \Disk\r910\onboard\hsbp\sas
Software Required
The management utility for integrated SAS hardware RAID and NIC can be
found in the EasyBUILD 7.1 build 300 (or later).
Software Version Directory on EasyBUILD
Intel RAID Web
Console 2
1.13-07 \app\r910\Integrated_SAS\Windows\
Broadcom
Advanced Control
Suite
7.7.6 \app\r910\NIC\BACS\2KXPWS03
Configuring Integrated SAS Hardware RAID
Please refer to the Appendix B. for the Integrated SAS hardware RAID
configuration.
Installation Tips
NOTE. There is no built-in driver for integrated SAS hardware RAID in the OS.
You need an USB floppy for applying driver during the OS installation.
1. As Windows Server 2003 can’t recognize the integrated SAS hardware
RAID, you need to make a driver diskette from the EasyBUILD 7.1 build
300 first before the installation.
2. Press F6 at the start of installation to provide the driver disk for the