User Guide

System Configuration 3-45
3.4.5 Channel Configuration
You may configure the backplane as single-channel (combine) or
dual-channel (split) controller.
In a single-channel configuration, channel 1 supports the SCSI
devices plugged into slots 1 to 7. Set the channel configuration
switches to “Combine” and set the terminators accordingly (Table 3-7)
to achieve a single-channel configuration. See Figure 3-33 for the
locations of the switches and terminators.
Figure 3-36 Single-Channel Configuration
Table 3-7 lists the terminator settings for the single-channel
configuration.
Connect to Wide
SCSI connector on
the system board or
SCSI controller board
Connect to external
SCSI devices
Connect SCSI
channel 1 to
slots 1 to 7