User Guide

System Configuration 3-11
3.1.4 Installing External Devices
The housing supports one 3.5-inch and three 5.25-inch external
devices. The empty drive bays on the upper front panel allow you
install additional external devices such as a CD-ROM drive, digital
audio tape (DAT) drive or another hard disk drive.
Your basic system comes with a CD-ROM
drive and a 3.5-inch diskette drive already
installed.
Follow these steps to install an external device:
1. Remove the upper front panel door and the front panel cover.
See Figures 3-5 and 3-6 for illustrations.
2. Attach the drive guides on the sides of the external device that
you wish to install.
Figure 3-11 Attaching the Drive Guides
If you are installing a SCSI device, set its
SCSI ID. Set the terminator if the SCSI
device is the last one on a SCSI bus.