User Guide

xvi
3-14 Pulling Out a Hot-swap Drive Tray ......................... 3-14
3-15 Connecting the Drive Cables (Wide SCSI Drive)....3-15
3-16 Connecting the Drive Cables
(Narrow SCSI Drive).............................................. 3-15
3-17 Installing a Hot-swap Drive Tray............................. 3-16
3-18 Locking the Drive Tray Switch................................3-17
3-19 Removing a Bracket Cover ....................................3-17
3-20 Installing a PCI Expansion Board ...........................3-18
3-21 Removing the Thermal Air Guide........................... 3-20
3-22 Reinstalling the Thermal Air Guide.........................3-21
3-23 System Board Layout............................................. 3-22
3-24 Jumper and Connector Locations...........................3-23
3-25 Attaching the Sliding Heat Sink to the CPU............3-29
3-26 Installing a Pentium Pro CPU.................................3-30
3-27 Installing the Hook-Type Heat Sink and Fan........... 3-32
3-28 Memory Board Layout............................................ 3-33
3-29 Installing a DIMM ...................................................3-36
3-30 Removing a DIMM................................................. 3-37
3-31 Inserting the Memory Board ...................................3-38
3-32 Attaching the Board Holding Clamp........................3-39
3-33 SCSI Disk Array Backplane Board .........................3-42
3-34 Settings for Jumpers J3 and J4.............................. 3-43
3-35 Hard Disk ID Switch Settings.................................. 3-44
3-36 Single-Channel Configuration.................................3-45
3-37 Dual-Channel Configuration ...................................3-47
3-38 Removing the Drive Bay Covers............................ 3-48
3-39 Installing a Backplane Board..................................3-49