User Guide

3-62 AcerAltos 19000Pro4 System Guide
3.6.2 Charger Board and Battery Box
Unplug the power cable from the wall socket
and remove all power supply units before you
install or remove a battery box or a charger
board.
Installing a Charger Board and a Battery Box
Follow these steps to install a charger and a battery box:
1. Remove the right panel door as in Figure 3-4.
2. Remove the two screws that secure the metal bar over the power
supply enclosure. Save the screws.
3. Pull-out the metal bar from the lower end and unhook the upper
end from the housing roof. See Figure 3-45.
4. Unpack a charger board.
5. Remove the screws that secure the charger compartment metal
cover.
Figure 3-53 Removing the Charger Compartment Metal Cover