Datasheet

Thermal Specifications
126 Intel
®
Xeon
®
Processor 5500 Series Datasheet, Volume 1
Note: The codes explicitly defined in this table may be useful in PECI originator response
algorithms. All reserved or undefined codes may be generated by a PECI client device,
and the originating agent must be capable of tolerating any code. The Pass/Fail mask
defined in Table 6-27 applies to all codes and general response policies may be based
on that limited information.
6.3.5 Originator Responses
The simplest policy that an originator may employ in response to receipt of a failing
completion code is to retry the request. However, certain completion codes or FCS
responses are indicative of an error in command encoding and a retry will not result in
a different response from the client. Furthermore, the message originator must have a
response policy in the event of successive failure responses.
Please refer to the definition of each command in Section 6.3.2 for a specific definition
of possible command codes or FCS responses for a given command. The following
response policy definition is generic, and more advanced response policies may be
employed at the discretion of the originator developer.
Table 6-28. Device Specific Completion Code (CC) Definition
Completion
Code
Description
0x00..0x3F Device specific pass code
0x40 Command Passed
0x4X Command passed with a transaction ID of ‘X’ (0x40 | Transaction_ID[3:0])
0x50..0x7F Device specific pass code
CC: 0x80 Error causing a response timeout. Either due to a rare, internal timing condition or a
processor RESET condition or processor S1 state. Retry is appropriate outside of the RESET
or S1 states.
CC: 0x81 Thermal configuration data was malformed or exceeded limits.
CC: 0x82 Thermal status mask is illegal
CC: 0x83 Invalid counter select
CC: 0x84 Invalid Machine Check Bank or Index
CC: 0x85 Failure due to lack of Mailbox lock or invalid Transaction ID
CC: 0x86 Mailbox interface is unavailable or busy
CC:0xFF Unknown/Invalid Mailbox Request
Table 6-29. Originator Response Guidelines
Response After 1 Attempt After 3 attempts
Bad FCS Retry Fail with PECI client device error
Abort FCS Retry Fail with PECI client device error. May be due to illegal command codes.
CC: Fail Retry Either the PECI client doesn’t support the current command code, or it has
failed in its attempts to construct a response.
None (all 0’s) Force bus idle
(1ms low), retry
Fail with PECI client device error. Client may be dead or otherwise non-
responsive (in RESET or S1, for example).
CC: Pass Pass n/a
Good FCS Pass n/a