Specifications

Transmitter Controls
NOTE
Set the ON/OFF switch on “OFF” position before charging. The
charger plug must be correct type (“+” inside and “-“outside, type
TAMIYA N-3U or equivalent). Using the wrong type may explode,
causing personal injuries and damages.
Servo reverse:
The 4 switches reverses the direction of the
Ch1~Ch4 servos.
2
15.
4
2
3
13
12
15
9
8
10
14
11
5
1
6
7
Right Stick: Throttle/Aileron control for Mode1 type. Elevator/Aileron
control for Mode 2 type.
Left Stick: Elevator/Rudder control for Mode1 type. Throttle/Rudder
control for Mode 2 type.
Channel Trim TAB: Trim tabs to trim the control to neutral position
for corresponding servos / channel.
Power Switch: Turn the transmitter on or off.
Antenna: Adjust the antenna to proper direction before flying.
Please refer page 9 ”Addittional Note for 2.4GHz Radio System”.
Voltage Indicator: LED light indicates transmitter battery condition.
When blinking, the battery should be replaced / charged.
Handle: For carrying the transmitter.
Binding Switch: Performs binding process. Also used to perform
range checking.
Mixing Function Switch: Default setting is on middle “NOR”
position. Re-set to access the V-Tail or ELEVON mixing control
functions.
Simulator mini USB Connector Port: Designed for by-wire signal
transmission and communication between transmitter and
computer.
Charging Jack: To recharge the transmitter battery.
For rechargeable Nicd and NiHM battery pack only.
1.
2.
3~6.
7.
8.
9.
10.
11.
12.
13.
14.