User manual

Front View — Receiving Unit EX-G007-RX
HDMI-OUT: Connect to a HDMI display with a HDMI M-M cable here.
HDMI-OUT
E
Q
EQ: Adjust the 8-level equalization control knob to the received HDMI signals. 0 – 7 = strongest –
weakest. It is recommended to switch from 7 to 0 to find the optimal visual experience.
Rear View — Receiving Unit EX-G007-RX
RJ45-IN: Plug in a CAT-5/5e/6 cable that needs to be linked to the RJ-45 connector of the transmitting
unit EX-G007-TX.
RJ45-IN
+5V DC
+5V DC: Connect to 5V DC power supply.
Hardware Installation
1. Connect your HDMI/DVI source (such as a Blu-ray Disc player) to the transmitting unit
EX-G007-TX.
2. Connect your HDMI/DVI display (such as a LCD TV) to the receiving unit EX-G007-RX.
3. Connect your CAT-5/5e/6 LAN cable between the transmitting and receiving units.
4. Make sure your CAT-5/5e/6 LAN cable is tightly connected and not loose.
5. Plug in 5V DC power cord to the power jack of the receiving unit EX-G007-RX.
6. Plug in 5V DC power cord to the power jack of the transmitting unit EX-G007-TX.
7. If a flickering or a blinking image is seen, try to adjust the rotational switch to improve the
cable skew. 0 stands for the strongest EQ while 7 stands for the weakest. Try adjusting the
EQ from 7 to 0.
Headquarters :
9F-2., No. 190 Sec. 2 Jung Shing Rd.,Hsin-dian,
Taipei, Taiwan 231
TEL: [phone]
FAX: [phone]
Website: www.ace-plus.com
Page 6 of 8
ACE PLUS CORP.