User manual

Panel Descriptions
Front View — Transmitting Unit EX-G007-TX
HDMI-IN: Connect to a HDMI source with a HDMI M-M cable here
Mode
HDMI-IN
Mode: 0 = HDMI mode with surround sound audio output
1 = HDMI mode with stereo audio output
2 = DVI mode
3~5 = Reserved
6 = Use default EDID*
7 = Learn EDID from the display
Note for EDID (Extended Display Identification Data) learning
1. Please connect the display which you want to read EDID with a HDMI cable to the
transmitter’s HDMI-IN and turn Mode to 7 so the TX can learn the EDID information from
the connected HDTV. The LED on the RJ45-OUT of TX will dim and light again in a few
seconds, which indicates the EDID learning process is completed.
2. Turn Mode clockwise from Mode 7 to Mode 0 or Mode 1 for desirable audio setting and
enjoy the experience. DO NOT let the rotary arrow pass by Mode 6 which will erase the
EDID just learned and restore the default EDID.
Rear View — Transmitting Unit EX-G007-TX
+5V DC: Connect to 5V DC power supply.
RJ45-OUT
+5V DC
RJ45-OUT: Plug in a CAT-5/5e/6 LAN cable that needs to be linked to the RJ-45 connector of the
receiving unit EX-G007-RX.
ACE PLUS CORP.
Headquarters :
9F-2., No. 190 Sec. 2 Jung Shing Rd.,Hsin-dian,
Taipei, Taiwan 231
TEL: [phone]
FAX: [phone]
Website: www.ace-plus.com
Page 5 of 8