ACE PLUS CORP. VGA over Single CAT5 Series EX-G029B VGA & Audio over CAT5 Extender with RGB Delay Control User Manual EX-G029B-TX Page 1 of 8 EX-G029B-RX Headquarters : 9F-2., No. 190 Sec. 2 Jung Shing Rd.,Hsin-dian, Taipei, Taiwan 231 TEL: +886-2-2912-4201 FAX: +886-2-2912-3164 Website: www.ace-plus.
ACE PLUS CORP. Safety and Notice The EX-G029B VGA & Audio over CAT5 Extender with RGB Delay Control has been tested for conformance to safety regulations and requirements, and has been certified for international use. However, like all electronic equipments, the EX-G029B should be used with care. Please read and follow the safety instructions to protect yourself from possible injury and to minimize the risk of damage to the unit. z Follow all instructions and warnings marked on this unit.
ACE PLUS CORP. Introduction With only one cost effective CAT-5e cable, the EX-G029B lets you extend VGA (WUXGA) to cover the distance up to 330m (1,000ft). The devices are composed of a transmitter and a receiver. The transmitter EX-G029B-TX is installed near the signal source, and the receiver EX-G029B-RX is placed near the desired display. With built-in EQ and GAIN control, the transmission path can be adjusted to adapt the cable quality and video bandwidth.
ACE PLUS CORP. Specifications & Package Contents Model Name Technical Role of usage Video bandwidth Video support Transmission Audio support Input video signal Equalization RGB delay control ESD protection PCB stack-up Input Output VGA connector RJ-45 connector 3.
ACE PLUS CORP. Panel Descriptions Front Panel — Transmitting unit (EX-G029B-TX) 1 2 3 1. +5V DC power jack: Connect to 5V DC power supply 2. VGA IN: VGA input from a video source 3. Audio IN: Connect to an analog audio source Rear Panel —Transmitting unit (EX-G029B-TX) 4 4. RJ-45 OUT: Plug in a CAT-5/5e/6 cable that needs to be linked to the RJ-45 connector of the receiving unit EX-G029B-RX. Page 5 of 8 Headquarters : 9F-2., No. 190 Sec. 2 Jung Shing Rd.
ACE PLUS CORP. Front Panel —Receiving unit (EX-G029B-RX) 8 5 6 7 5. Audio OUT: Connect to an analog audio output 6. S/PDIF OUT: Connect to an S/PDIF digital audio output 7. VGA OUT: VGA output to a remote video display 8. LED power indicator Rear Panel —Receiving unit (EX-G029B-RX) 9 10 113 12 13 14 15 9. +5V DC power jack: connect to 5V DC power supply 10. RJ-45 IN: Plug in a CAT-5/5e/6 cable that needs to be linked to the RJ-45 connector of the transmitting unit EX-G029B-TX. 11.
ACE PLUS CORP. Hardware Installation 1. Connect your VGA and audio source to the transmitting unit. 2. Connect your display and speakers to the receiving unit. 3. Connect your CAT-5/5e/6 cable between the transmitting and receiving units. 4. Make sure your CAT-5/5e/6 cable is tightly connected and not loose. 5. Plug in 5V DC power cord to the power jack of the receiving unit. 6. Plug in 5V DC power cord to the power jack of the transmitting unit. 7.
ACE PLUS CORP.
