User Guide

Chapter 5: Editing
159
3. Do one of the following:
x Click Done to accept your changes and close the Sheet Metal tab.
x Click Cancel to discard your changes and close the tab.
Sheet Metal options
Rounding Specifies the amount of curve in the edges of the impressions.
Detail Specifies the amount of detail in the impression.
Angle Specifies the angle of the grain in the sheet metal.
Metal color Specifies the color of the sheet metal.
Direction Specifies the direction in which the sheet metal was manipulated. Select
one of the following:
x Indented: stamps the metal from the top side of the image.
x Pushed out: stamps the metal from underneath the image.
Applying a Shift effect
You can use the Shift effect to divide your images into bars and shift them in random
directions. You can save your options as a preset for future use.
To apply a Shift effect:
1. On the Edit Panel, click Effects, and then double-click Shift.
2. On the Shift tab, set the options as described below.
3. Do one of the following:
x Click Done to accept your changes and close the Shift tab.
x Click Cancel to discard your changes and close the tab.
Shift options
Strength Specifies the amount of shift between the bars.
Width Specifies the width of each bar.
Angle Specifies the angle of the bars.
Background
color
Specifies the background color of the filtered image. Select the Image
check box to use the original image colors, or click the color picker to
select a different color.