User Guide

Chapter 5: Editing
123
4. Drag the Temperature slider to select a specific color temperature.
5. Drag the Tint slider to the left (more green) or right (more magenta) to match the
settings you used when you took the photo.
6. Click Reset to reset all options to the default.
To increase or decrease Saturation:
1. Drag the Saturation slider to the left or right to increase or decrease the intensity of hues
(color) in the photo.
2. To remove all the color and create a grayscale image, drag the slider all the way to the
left.
Batch Processor Channel Mixer options
The Channel Mixer in the Batch Processor can change multiple images to creates a rich
grayscale. Because you can control the brightness of the red, green, and blue channels, as well
as the overall brightness, you can use the Channel Mixer to emphasize different areas or
aspects of a photo, as well as alter it's mood and tone.
If you hover your mouse over each slider and watch the effect on the small preview below the
controls, it shows you which parts of the image will be affected by each channel. This helps to
gauge the effect of each slider on the image.
To create a grayscale image:
1. In Edit Mode, on the Edit Panel, click Color.
2. Select the Channel Mixer tab.
3. Do any of the following:
x Drag the Percent Red slider to the left or right.
The more red there is in a pixel, the more effect the red slider has on that pixel. So
the area of red in the picture is brightened or darkened more than other areas.
x Drag the Percent Green slider the left or right.
The more green there is in a pixel, the more effect the red slider has on that pixel.
So the area of green in the picture is brightened or darkened more than other areas.
x Drag the Percent Blue slider to the left or right.
The more red there is in a pixel, the more effect the red slider has on that pixel. So
the area of blue in the picture is brightened or darkened more than other areas.
x Drag the Brightness slider to the right or left to brighten or darken the whole image
4. Do one of the following:
x Click Done to apply your changes and close the tool.
x Click Cancel to discard all changes and close the tool.