User Guide

Chapter 2: Documents and Setup
Printer Options PS L2 (Faster printing of text): Allows you to send a block of text to
the printer for faster printing of text. If disabled, text is sent character
by character.
Screen enhancement feature for true halftones: This option,
when enabled, always prints halftones at the highest possible LPI. If
disabled, a halftone is printed at the printer’s resolution.
Document bleed size: By default, the bleed size is set to 9 pt (1/8 in).
Enter a new value in the text field.
Registration marks
Define the appearance of the registration marks. By default, the fill is white and the size is 72 pts
(see "Drawing registration marks manually" on page 302).
Measurements settings
In the Configuration Center, in the Measurements folder, you can define units, setup grids and
guides, and set the unit of measure used in the rulers and drawing scale.
Define units
You can further customize the rulers by adding units of measurements, modifying the definitions of
existing ones, or deleting them (see "Setting up rulers" on page 74).
Units To add units: Click the Add button. In the Add Unit dialog box, enter a
Unit name, Plural name, and Abbreviation. Select a Length and unit of
measurement on which to base the new unit. Select the Minor divisions
for the unit; e.g., if you wanted to have a unit that was based on 1 inch,
enter 1 for Length and select inches from the menu. Then, select the
Minor divisions that you want to use.
You can add this unit to any future documents by selecting the
Add to all new documents check box in the Add Unit dialog box.
To modify units: Select an existing unit and then click the Modify
button. In the Modify Unit dialog box, you can change the Abbreviation
and Minor divisions.
117