User Guide

Disabling a plug-in and changing their order
When you have a more than one plug-in that supports a certain file format, or a
plug-in that you do not want to use, you can disable plug-ins or change the order
that ACDSee uses them.
Disabling a plug-in
You can disable plug-ins in the Plug-in Settings dialog box so that ACDSee no
longer uses a specific plug-in.
To disable a plug-in:
1. In the Plug-in Settings dialog box, select one of the Plug-in tabs.
2. Clear the check box beside the plug-in name that you don’t want ACDSee
to use.
3. Click OK.
Changing plug-in order
There are certain file formats that are supported by more than one plug-in.
However, when this happens, you can control which plug-in is used to read or
write a file format. The order that plug-ins appear in the Plug-in Settings dialog box
is the order that ACDSee uses the plug-ins to read or write a file.
To change the plug-in order:
1. In the Plug-in Settings dialog box, select one of the Plug-in tabs.
2. Select a plug-in name in the Plug-ins list.
3. Do one of the following:
• Click the Move up button to move the plug-in higher in the list.
• Click the Move down button to move the plug-in lower in the
list.
4. Click OK.
Susie plug-ins do not have the features and speed of ACD Systems’
plug-ins. Therefore, it is recommended that you give Susie plug-ins a low
priority to prevent them from being used over an ACD Systems’ plug-in.
Also, you can disable Susie plug-ins that overlap the file formats that
ACD Systems’ plug-ins support.
145