User Guide

9
4.7 CONNECTION CONFIGURATION FOR DRAFT
MEASUREMENTS
1. Temperature Port T2 for Gas Temperature
2. Temperature Port T1 for Air Temperature
3. Gas Inlet Port
4. Port P1 (Not Used When Carrying Out a Draft Measurement)
5. Port P2 for Draft Measurements
4.8 MENU STRUCTURE
The BluFlame organizes all available actions into three main menus:
• Measurement
• Storage
• Extras
To switch between main menus, tap the context menu and select the main
menu you want there.
Measurement menu (1):
All actions for the measurement tasks that can be carried out with the
BluFlame. All installed measuring tasks are selected and run from here.
Storage menu (2):
All actions for managing storage.
Extras menu (3):
All other actions for managing and configuring the BluFlame.
Measurement menu: Please refer to section 7,
“Carrying out measurements,” on page 13.
Storage Menu: Please refer to section 8, “Storage,” on page 14.
Extras Menu: Please refer to section 9, “EXTRAS / Settings,” on page 16.
Initial Setup
Once the BluFlame is ready for operation, you can take advantage of the
initial setup to configure a number of settings as required for your specific
needs. All settings can be changed at any time.
5.1 GETTING THE BLUFLAME READY FOR OPERATION
The BluFlame is shipped fully assembled and
ready for use.
• Unpack the BluFlame and fully read the operating instructions.
• Check the BluFlame to make sure it is complete and undamaged.
• Charge the battery for 8 hours before using the device for the first time.
• Turn on the BluFlame (please refer to section 4.1, “Turning the BluFlame on
and off,” on page 7).
• Select the following:
 ➡ Menu: Extras ➡ Date & time.
• Set the date and time.
✔ The BluFlame is now ready for operation.